Issue with Database connection when switch to "Execute actions - In parallel

Jan Kurtak

• 2022年08月16日 08:43

Hi all,

I am trying to speed up executing incoming files by swith actions from Sequential to parallel. But there is some issue, in sequential mode it's working fine, but in parallel mode I am still getting error "Unable to run action 'For Each Database Record' because the record set source has not been set or is empty". I tryed to define database connection many times and still the same issue. In sequential working fine. Please help.

Regards

Jan

0

• 

  Peter Thane

  ★ BarTender Hero ★

  • 2022年08月16日 13:16

  Have you tried adjusting the polling interval on the File>Detection screen as this should improve the response time of the triggering. 

  I dont think the parallel/sequential works as you think it does. Each file will trigger the integration to run and so there is only one record set in the trigger file hence why you are receiving the error, or at least that is what I think is happening. 

   

  0

請登入寫評論。