Labels up on Printing
Hello everyone,
When printing by the bartender when there are multiple labels to be printed, pull the label up.
I'm using citizen CL-S700, the label is 10x10mm …
0
-
Not 100% sure what you mean but it sounds like it could be a label/page setup issue, have you checked/measured the label settings and enabled Gap/Transmissive mode? The page size should be the height of the label itself (ignore the inter-label gap as the sensor will pick this up) whilst the page width is the width of the label plus the gap either side with those set on Layout tab
0
Please sign in to leave a comment.
Comments
1 comment