Label size accuracy

Philip Richardson

• 17. September 2021 09:55

Hi everyone, currently using v10.1 and I was just wondering if there is any way to allow dimensions to be specified to 2 decimal places? or if this has been added to a newer version.

Normally working to 1 decimal place is not a major problem when setting up label templates, but i have recently had a job that is on a 203.2mm page, the label size is 45mm wide, 5mm high with a 5.16mm gap 20 labels per page.

At the moment i can either set my label gap to 5.1 or 5.2mm the problem is that this leads to a 1.2mm run out over the page (20 labels) on a larger label this wouldn't be too much of an issue, but when the label is only 5mm high, 1.2mm is quite noticeable. 

0

• 

  Peter Thane

  ★ BarTender Hero ★

  • 19. September 2021 17:43

  In BarTender 2021 R6 the interlabel gaps can still only be set to one decimal place but I wonder if you can achieve what you are trying to do via using either a Table data object or else by enabling Page Templates. Neither of these are in you version however but you could download the Trial version of 2021to a computer that is currently not running 10.1 and see if they are of use

  0
• 

  Brett Peach

  ★ BarTender Hero ★

  • 29. März 2022 22:17
  • Bearbeitet

  Thanks, Philip and Peter.

  I also have a similar request to allow for another decimal place in the Page Setup > Layout editors. Rounding to the nearest tenth of a millimeter can really add up for label template that's intended to print in multiples across a large grid/page.

  @SeagullScientific: can this be a consideration for a future improvement?
  (Current installation: Automation 2021 R3)

  1

Bitte melden Sie sich an, um einen Kommentar zu hinterlassen.